Controls steering bridgeUpdated a month ago
Required Tools:
- Allen key 2.5 mm
- Allen key 3 mm
- Allen key 5 mm
- Scissors
- Insulating tape or shrink tubing
- Hot air dryer or lighter
The wiring of your steering bridge is hidden behind your front light. Remove the front light by loosening the retaining screw behind this hole as shown in the image.
Both screws that hold the light cover in place are now visible. Remove both the screws.
Loosen the handlebar clamp. This is screwed into the handlebar head with 4 Allen screws.
Depending on which control element has to be changed, remove all elements on the corresponding side of the scooter to route the cables inside the handlebar.
Attaching the thumb throttle
Fastening the brake levers
Loosen the shrink tubing of the elements that have to be replaced and pull these elements off the steering bridge.
Before attaching new elements, prepare the shrink tubing if necessary and place it over the plug connections.
Then reattach all elements to the handlebar and insulate the plug connections.
Now reattach the handlebar under the steering head and mount the front light cover and the light itself.