Required Tools:. The disassembly of the front wheel begins at the cover of the front fork. You will find the corresponding screws at the connection of the two sides. and behind the two reflectors. Remove the drum brake by loosening the drum brake adj
Required Tools:. If you want to change the tire, you will need:. Remove the rear axle cover. Then, disconnect the motor plug. Remove both nuts and take the motor out downwards. To change the tire, take the motor and place it on a stable surface or cl
Required Tools:. Loosen the mudguard screw connection by loosening the four screws on the mudguard. Loosen the brace by removing the rear axle cover. Now, remove the rubber mat from the running board. Then, remove the running board cover. Remove the
Required Tools:. Remove the cover of your running board. Then loosen the screws on the running board. Inside the running board, find the plug connection to the charging socket. Disconnect it and loosen the nut.
Required Tools:. For best ride quality and safety, the folding mechanism may need to be adjusted because of settling from strong vibrations that can occur during transport or within the first few rides. Adjust your folding mechanism so that it is not
Required Tools:. Just as in bicycles, quickly adjust the track between the handlebars and the front wheel if necessary. Start with loosening the two clamping screws of the front wheel. Take the bike between your legs and align the handlebars. Then ti
Required Tools:. The wiring of your steering bridge is hidden behind your front light. Remove the front light by loosening the retaining screw behind this hole as shown in the image. Both screws that hold the light cover in place are now visible. Rem
Required Tools:. To change the light, first loosen the screw that holds the light. Pull the light forward out of the cover. If the cable gets caught here, optionally remove the light cover. Use a sharp object to cut open the shrink tubing. Be careful
Required Tools:. To remove the display cover, start by pushing both decorative tubes located on either side of the display mount to the side. Do this by loosening the brake lever on the left side. Don’t completely loosen the screws - just loosen them