VMAX Escooter USA logo
VMAX Escooter USA logo

All articles

VX2 Extreme

Fine adjustments of the folding mechanism

If the folding mechanism is very tight or has some issues, follow these steps. The fine adjustment is made using the hook at the bottom of the stem. loosen the large screw inside the mechanism. Adjust the angle of the hook using the small grub screw.

Change tire or casing

Required Tools:. To change the tire, take the motor and clamp it or  place it on a stable surface. Be careful not to damage the axle or the cable attachment.

Handlebar Alignment

The process to align the front wheel of the scooter with handlebars is quick. Loosen the clamp on your handlebar by loosening both screws shown in the pictures. Hold the front tire between the feet and turn the handlebars to the desired position. Now

Charging socket and cover

Required Tools:. The charging socket is installed in the maintenance flap at the front of the scooter. Therefore, remove the rubber mat at the front of the scooter and loosen the 4 screws (two at the top and two at the bottom of the footboard). Remov

Front wheel and drum brake

Required Tools:. Loosen the cable on the front wheel by unscrewing the nut and then unhooking the cable. Loosen the fixing screw. Loosen both cap nuts, you will have your front wheel loosely in your hand. Once the front wheel has been removed, replac

Controls and indicators

Required Tools:. The wiring for the steering bridge is hidden in the front bar. To access the relevant cables, remove the cover underneath the display. and remove the clamp fastening of the handlebar. All the plug connections that connect the display