It you need to replace the entire motor or just the casing mounted on the engine, follow these steps carefully. Ensure you have the following tools and materials ready:. Required Tools:. Now you have removed the motor. To install a new motor, follow
Required Tools:. First, loosen the cable on the front wheel. To do this, first unscrew the nut and then unhook the cable. Loosen the fixing screw.Loosen both cap nuts. The front wheel will now be free to remove. Required Tools:. Once the front wheel
Required Tools:. Changing your rear light begins - perhaps a little unexpectedly - at the front of the scooter. The plug connection of your scooter is hidden behind the front maintenance flap. To remove this maintenance flap, loosen the two screws lo
Required Tools:. To replace the rear indicators, begin at the front of the scooter. The plug connection for your indicators is hidden behind the front maintenance flap.
Required Tools:. Push both decorative tubes to the left and right of the display mount to the side. Loosen the switch for the indicator and the brake lever on the right side. You do not need to completely loosen the screws, just enough to move the el
Required Tools:. The wiring of the steering bridge is hidden behind the front light. To access it, first remove the front light by loosening the retaining screw located behind the light.You will see two screws holding the light cover in place. Loosen
Required Tools:. Loosen the screw that holds the light. Pull the light forward out of the cover. If the cable gets caught, you can optionally remove the light cover. Use a sharp object to carefully cut open the shrink tubing. Be cautious to avoid dam
To change your charging socket or the corresponding cover on your VX2 PRO, you need:. The charging socket is installed in the maintenance flap at the front of the scooter. Therefore, first, remove the rubber mat at the front of the scooter and then l
Required Tools:. If your folding mechanism is very stiff or has some play, you can fix it yourself. The fine adjustment is made using the hook at the base of the stem. Loosen the large screw inside the mechanism.Adjust the angle of the hook using the
Required Tools:. The process to align the front wheel of the scooter with the handlebars is quick. Loosen the clamp on the handlebar. To do this, loosen both screws shown in the pictures.Hold the front tire between feet and turn the handlebars to the
Required Tools:. Begin by determining whether you need to change the front or rear tire. Refer to the relevant instructions for removing the wheel before proceeding. Place the motor on a stable surface or secure it in a clamp. Take care not to damage
Required Tools:. Expose the display wiring by removing the front lamp. Remove the light cover held in place by 2 screws. Loosen the handlebar to gain easy access to the individual plug connections and the screw connection of the display cover. Handle